Automatic and manual baler use characteristics
Many customers in the strip packaging machine professional packaging machine manufacturers often refer to this inquiry: stand-alone use, but need a fully automatic baler. The advantages of automatic balers, in fact, automatic balers are mainly used to meet the power of the transmission line to use, the basic can not be used alone, mainly because of the following reasons: artificial and machine with easy to misuse.
The principle of the packer is the fifth step of the adhesive tape
Observe the bonding area of the adhesive tape. A little no bonding, see ② hot head there is no temperature, too high is not too low, packing belt put on the hot head just can melt can. Normal temperature control potential, in the second gear position can be.
Hot head temperature normal, can melt the packing belt with no glue. Check the hot head has no deformation, check the angle of the hot head, look at the operation when the overall operation of the hot head:
The level moves forward. If the hot head stuck fixed, adjust the hot head stopper, check the hot mouth of the strange pull the spring, hot head strange head of the top of the hot head there is no loose and the angle of the wrong, , And finally consider the mandrel of the mandrel with the corresponding cam piece. Hot head normal operation, check the knife / 2 knife, take out the cutter to see if the bottom of the bearing is not broken.
Pay attention to the observation, the situation on the skateboard, there is no fixed locking, and wear is not very serious.
Hot head does not heat, and in any gear are. Observe the fan has no work, (fan and hot head transformer is the same power cord 220V). Fan has work, can determine the hot head transformer coil problems. The fan does not work, look for the circuit carefully. From the power switch, fuse, to the fan and transformer cable. Fan and temperature transformer lines, is a separate line, not through the circuit board.
The packing machine of the automatic baler is packaged by the photoelectric sensor to be packaged with the packing belt. However, if the packing material is manually transported to the baler table, the misclassification or misuse of the baler will occur. Not conducive to packaging operations, but also for personal safety also have a certain impact.
Cost is high. The machine because of its high degree of automation, high configuration, so the cost of the price is relatively high, if the user stand-alone use, but to buy such a product, the production cost will be relatively high.
Operation is inconvenient. Can be manufactured according to customer needs, suitable for a variety of items bundled, desktop height can be adjusted with the conveyor belt, not limited to the size of packaging. All parts of the metal baler are machined with NC machining equipment for precision machining. Parts of the solid resistance and connection action of the unity have been well protected, long-term use will not be a problem.
Power wheel can achieve unmanned automatic packaging. Using the convex plate convex operation of the button design, greatly reducing the degree of damage to the operation button and misuse. Can be used according to the use of different freedom to adjust the time of the hot head delay circuit to increase the adhesion of the firmness. As the machine table table roller for the power roller, so after the completion of the packing operation, the machine will automatically send the product away, then the user must be in the back of the packer connected to the transmission line body, if not connected, It will fall directly to the ground. The metal baler uses a rugged and high-performance motor as the main body, completely free of oil-based structure design, easy maintenance. Machine can be installed before and after the conveyor belt and electric eye equipment, can make the package unmanned, fully automatic operation.